Task Order

Column notes:

Parts reqd: Shows purchased parts from the parts list that are required for the task. It generally does not list parts that were used in a previous task. It also does not list tools etc.
Involves: This may be useful for grouping tasks. For example, refer to it to concurrently do all of the tasks that require soldering.
Est time: In minutes. The times might be way off. Some times, indicated by **, do not take into account time required for glue to dry, during the task.

Round One

These tasks have no preceding tasks and can be done concurrently.

Task	Parts reqd	Involves	Est time
BEC Prep	BECs	-	10
XT to wires	XT connectors, heat shrink, wire	wire prep, solder, heat shrink	90
XT to parts	XT connectors, heat shrink, BECs, Quad ESCs	wire prep, solder, heat shrink	30
camera mount plates	Camera wood	cutting, drilling (or 3D print)	120
radio mount	airframe, radio	-	10
plane motor mount	airframe (one wood piece), plane motor & prop & holder & bushing & stop, M3 8mm screws & nuts	cutting, drilling	45
quad ESC solder	quad ESCs, quad motors	soldering	60
bracket prep	small brackets	drilling and/or cutting (or 3D print)	60
airspeed prep	airframe, airspeed sensor	-	15
servo setup	servos, battery, XT90 to XT60 adapter, BEC	-	15
GPS mount	GPS (included with flight controller), airframe, tapes	-	30
wood frame	airframe	-	30
receiver bind to transmitter	receiver, flight controller	-	15

*The estimated times might be way off.

These tasks requires at least one "Round One" task to be done first.

Task	Parts reqd	Preceding Tasks	Involves	Est time
quadarm prep	quadarm material, hardware	bracket prep	cutting, drilling (incl of pultruded carbon fiber), maybe 3D printing	120
camera assemble	camera, lens, dampers, 2-56 screws & nuts	camera mount plates	-	15
plane ESC mount	airframe, plane ESC, glue & velcro tape	plane motor mount	-	10
fuselage prep	airframe, spacers, GPS	quadarm prep, camera plates	-	60
receiver mount	airframe, receiver, tape & velcro tape	receiver bind	-	30
power loom nodes	wire, heat shrink, PM02 incl with flight controller	XT to wires	wire prep, solder, heat shrink	120
radio wires	radio	BEC prep	-	10
tail setup	airframe, radio antenna, glue & tape, servo lead extensions	servo setup	gluing	60**
wing setup	airframe, glue & tape, servo lead extensions	servo setup, GPS mount	gluing	45**
frame brackets	flight controller, screws	bracket prep, wood frame	-	20

*The estimated times might be way off.
**Does not take into account time required for glue to dry, during the task.

These tasks requires at least one "Round Two" task to be done first.

Task	Parts reqd	Preceding Tasks	Involves	Est time
quadarm assemble	heat shrink. screws	quadarm prep, quad ESC solder	heat shrink	30
battery velcro	battery, airframe, velcro straps, velcro tape	receiver mount	-	20
tail glue	airframe, glue	tail setup	gluing	30

Remaining tasks and rounds.